Sissejuhatus
Thank you for choosing the Stetsom Vulcan 9K EQ - 1 Ohm 9000W RMS Full Range High Power AmpSee kasutusjuhend annab olulist teavet teie seadme nõuetekohaseks paigaldamiseks, kasutamiseks ja hooldamiseks. ampelutõrjuja. Palun lugege enne toote kasutamist see kasutusjuhend hoolikalt läbi, et tagada optimaalne jõudlus ja ohutus.
Oluline ohutusteave
- Enne elektriühenduste tegemist ühendage alati sõiduki aku lahti.
- Elektriohu vältimiseks veenduge õige maandus.
- Installige amptõstuk hästi ventileeritavas kohas, et vältida ülekuumenemist.
- Use appropriate gauge wiring for power and speaker connections as specified in this manual.
- Vältige toote paljastamist ampniiskuse või äärmuslike temperatuuride eemaldaja.
- Ärge püüdke avada ega parandada ampise. Pöörduge kogu hoolduse eest kvalifitseeritud personali poole.
Toode läbiview
The Stetsom Vulcan 9K EQ is a high-power, full-range digital amplifier designed for automotive audio systems. It features a robust design and advanced equalization capabilities to deliver powerful and clear sound reproduction.
Peamised omadused:
- 9000W RMS power output at 1 Ohm (12.6V)
- Full Range frequency response (10Hz to 15KHz)
- Built-in 3-band equalizer (Bass, Mid Bass, Mid High)
- Over Clip +15% Power indicator
- Protection circuits for safe operation
Komponendi identifitseerimine:
The amplifier features power, protection, and clip indicators on the front panel. The input and output terminals are located on the side for easy access during installation.
Paigaldamine ja seadistamine
1. Power Connections:
- Power Cable (B+): Connect a heavy-gauge power cable directly from the positive terminal of the vehicle's battery to the B+ terminal on the amplifier. An inline fuse or circuit breaker (not included) must be installed within 18 inches (45 cm) of the battery.
- Ground Cable (GND): Ühendage paks maanduskaabel GND-klemmilt seadmel. ampKinnitage liimimisvahend sõiduki šassii puhtale, värvimata metallpinnale. Veenduge, et ühendus oleks kindel ja väikese takistusega.
- Kaugjuhtimisega sisselülitamine (REM): Ühenda peakomplekti kaugjuhtimisväljundi kaugjuhtimisjuhe raadiojaama REM-pesaga. ampSee juhe annab märku amplisaseadet helisüsteemiga sisse ja välja lülitamiseks.
2. Helisisendi ühendused:
Connect RCA cables from your head unit's pre-out (RCA output) to the RCA input jacks on the amplifier. Ensure correct left and right channel connections if applicable, though this is a mono ampelujõulisem.
3. Kõlarite väljundühendused:
Connect your subwoofer(s) or full-range speakers to the speaker output terminals on the amplifier. Pay close attention to polarity (+ and -) and ensure the total impedance of your speakers matches the amplifier's rated impedance (1 Ohm for this model). Refer to the specifications section for impedance details.
4. Paigaldamine:
Paigaldage amplifier securely in a location that provides adequate ventilation and protection from moisture. Avoid mounting it directly on carpet or in enclosed spaces without airflow.
Kasutusjuhised
1. Esialgne sisselülitamine:
After all connections are made, reconnect the vehicle's battery. Turn on your head unit. The "POWER" indicator on the amplifier should illuminate, indicating it is receiving power and is operational.
2. Gain Adjustment:
Reguleerige võimenduse regulaatorit ampväljundmahule vastavaks muutjatage of your head unit. Start with the gain at its minimum setting. Play a familiar track at about 75% of your head unit's maximum volume. Slowly increase the amplifier's gain until you hear distortion, then back it off slightly. The "CLIP" indicator should only flash briefly on very dynamic peaks, not stay illuminated.
3. Crossover Settings:
The Vulcan 9K EQ features adjustable crossovers:
- Madalpääsfilter (LPF): Adjust this control to set the upper frequency limit for your subwoofers. Frequencies above this setting will be attenuated.
- Kõrgpääsfilter (HPF): Adjust this control to set the lower frequency limit for your speakers. Frequencies below this setting will be attenuated. This is typically used for full-range speakers or mid-bass drivers.
Refer to your speaker manufacturer's recommendations for optimal crossover points.
4. Equalizer Adjustment (3-Band EQ):
The amplifier includes a 3-band equalizer to fine-tune the audio output:
- Bass: Reguleerib madalsageduslikku vastuvõttu.
- Keskmine bass: Adjusts the mid-low frequency response.
- Keskmine kõrge: Adjusts the mid-high frequency response.
Make small adjustments and listen carefully to achieve your desired sound balance. Avoid excessive boosting, which can lead to distortion or speaker damage.
Hooldus
- Hoidke ampPuhastage tõstuk tolmust ja prahist vabana. Puhastamiseks kasutage pehmet ja kuiva lappi.
- Tagage piisav õhuvool ümber amplifier at all times to prevent overheating. Regularly check that cooling fins are not obstructed.
- Kontrollige regulaarselt kõiki juhtmestiku ühendusi tiheduse ja korrosiooni suhtes. Lõdvad ühendused võivad põhjustada jõudlusprobleeme või kahjustusi.
Veaotsingu juhend
| Probleem | Võimalik põhjus | Lahendus |
|---|---|---|
| Ei voolu / Amptõsteseade ei lülitu sisse |
|
|
| Heliväljund puudub |
|
|
| Amplifier in Protection Mode (PROT light on) |
|
|
| Moonutatud heli |
|
|
Tehnilised andmed
| Funktsioon | Väärtus |
|---|---|
| RMS Power at 1 Ohm (12.6V) | 1 x 9,000 W RMS |
| RMS Power at 2 Ohm (12.6V) | 1 x 5,400 W RMS |
| RMS Power at 4 Ohm (12.6V) | 1 x 3,200 W RMS |
| RMS Power at 1 Ohm (13.8V) | 1 x 10,000 W RMS |
| RMS Power at 2 Ohm (13.8V) | 1 x 6,400 W RMS |
| RMS Power at 4 Ohm (13.8V) | 1 x 3,900 W RMS |
| Supply Voltage | 9.5 ~ 15V |
| Sagedusvastus | 10Hz ~ 15KHz |
| Crossover Low Pass | 50Hz ~ 15KHz |
| Crossover High Pass | 10Hz ~ 70Hz |
| Signaali ja müra suhe | > 90 dB |
| Harmonic Distortion (THD) | < 0.9 % |
| Sisendtundlikkus | 0.2V |
| Sisendtakistus | 27K oomi |
| Väljundtakistus | 1 oomi |
| Consumption (Musical Signal) | 6.7A ~ 445A (12.6V) |
| Consumption (Bass Signal) | 6.7A ~ 890A (12.6V) |
| Mõõdud (K x L x S) | 75.5 x 308 x 510 mm |
| Kaal | 7.4 kg |
Garantii ja tugi
Stetsom products are manufactured to the highest quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Stetsom website. For technical support or service inquiries, please contact your authorized Stetsom dealer or Stetsom customer service.
Websait: www.stetsom.com.br (Ntamplink, tegelik link võib erineda)
