Marley T200 Qmark elektriliini mahttagSeinale paigaldatava termostaadi kasutusjuhend

1. Sissejuhatus

This manual provides detailed instructions for the installation, operation, and maintenance of the Marley T200 Qmark Electric Line Voltage Wall Thermostat. The T200 is a wall-mounted, double-pole, heating-only thermostat designed for precise control of electric heating systems. It features a built-in heat anticipator for consistent temperature regulation and a snap-action design for extended operational life. Please read this manual thoroughly before installation and use.

2. Ohutusalane teave

HOIATUS: Risk of electric shock. This device operates on line voltage (277 Volts). Improper installation or handling can result in serious injury or death. Always turn off power at the main service panel before installing or servicing this thermostat.

• Paigalduse peab teostama kvalifitseeritud elektrik vastavalt kõigile kohalikele ja riiklikele elektrieeskirjadele.
• Do not install in locations where it may be exposed to water or excessive humidity.
• Veenduge, et kõik juhtmestiku ühendused on kindlad ja korralikult isoleeritud.
• Ärge ületage ettenähtud mahtutage or current ratings of the thermostat.

3. Pakendi sisu

Enne paigaldamise alustamist veenduge, et kõik komponendid on olemas:

• Marley T200 Line Voltage Seinatermostaat
• Kinnituskruvid (tavaliselt kaasas)
• Kasutusjuhend (see dokument)

4. Paigaldamine

The Marley T200 thermostat is designed for wall-mount installation. Ensure the power supply to the heating system is disconnected at the circuit breaker before proceeding.

4.1 Juhtmestik

The T200 thermostat requires a 277 Volt power supply. It features three pre-stripped wires for connection:

• Connect the two red wires to the incoming 277V line voltage pakkumine.
• Connect the black wire to the heating load (e.g., electric heater).
• Ensure all connections are made using appropriate wire nuts or connectors and are securely tightened.

Refer to the diagram below for visual guidance on the thermostat's wiring and components.

Joonis 1: The Marley T200 thermostat showing its off-white rectangular body, a brass-colored temperature dial with markings from 50 to 90 degrees Fahrenheit and an 'OFF' position, and three exposed electrical wires (two red, one black) extending from the left side for connection to the line voltage and heating load. The 'MARLEY' brand name is visible at the bottom front.

4.2 Paigaldamine

After wiring, carefully push the thermostat into the wall box. Secure the thermostat to the wall box using the provided mounting screws. Ensure the thermostat is flush with the wall surface.

5. Kasutusjuhised

The Marley T200 thermostat features a simple manual control dial for setting the desired temperature.

• Temperatuuri reguleerimine: Rotate the central dial clockwise to increase the desired temperature or counter-clockwise to decrease it. The temperature range is from 50°F to 90°F.
• VÄLJAS asend: To turn off the heating system, rotate the dial counter-clockwise until it reaches the 'OFF' position. This will completely disconnect power to the heating load.
• The built-in heat anticipator helps maintain a consistent room temperature by cycling the heating system more frequently for shorter durations, preventing wide temperature swings.

6. Hooldus

The Marley T200 thermostat requires minimal maintenance.

• Puhastamine: Pühkige termostaadi välispinda regulaarselt pehme ja kuiva lapiga tolmu eemaldamiseks. Ärge kasutage abrasiivseid puhastusvahendeid ega lahusteid.
• Kasutaja poolt hooldatavaid osi pole: Termostaadi sees ei ole kasutaja poolt hooldatavaid osi. Ärge proovige seadet avada ega parandada.

7. Veaotsing

If you experience issues with your Marley T200 thermostat, consider the following:

• Soojust pole:
  • Check if the thermostat dial is set to the 'OFF' position.
  • Ensure the circuit breaker for the heating system is not tripped.
  • Verify that the thermostat is properly wired and all connections are secure (consult a qualified electrician if unsure).
• Ebaühtlane temperatuur:
  • Veenduge, et termostaat ei asuks soojusallikate lähedal (nt otsene päikesevalgus,amps) or drafts, which can affect its accuracy.
  • The thermostat has a differential of 2.5 degrees, meaning it will cycle the heat within a 2.5-degree range of the set point.

For persistent issues, contact a qualified electrician or Marley customer support.

8. Tehnilised andmed

9. Garantii ja tugi

Specific warranty information for the Marley T200 thermostat is not provided in this document. For details regarding warranty coverage, technical support, or replacement parts, please contact Marley customer service directly or refer to the official Marley websait. Hoidke ostutšekk ostutõendina alles.